User manual

MPLAB
®
REAL ICE
™
In-Circuit Emulator User’s Guide
DS51616B-page 100 © 2008 Microchip Technology Inc.
11.3.1 Breakpoints Dialog
To set up breakpoints, select Debugger>Breakpoints.
Set up different types of breakpoints in this dialog. Click on Add Breakpoint to add
breakpoints to the dialog window. Depending on your selected device, there may be
other buttons for more advanced breakpoint options.
11.3.1.1 BREAKPOINT DIALOG WINDOW
Information about each breakpoint is visible in this window.
Once a breakpoint has been added to the window, you may right click on it to open a
menu of options:
• Delete – delete selected breakpoint
• Edit/View – open the Set Breakpoint Dialog
• Delete All – delete all listed breakpoints
• Disable All – disable all listed breakpoints
11.3.1.2 BREAKPOINT DIALOG BUTTONS
Use the buttons to add a breakpoint and set up additional break conditions. Also, a
stopwatch is available for use with breakpoints and triggers.
TABLE 11-1: BREAKPOINT DIALOG WINDOW
Control Function
Breakpoint Type Type of breakpoint – program or data
Address Hex address of breakpoint location
File Line # File name and line number of breakpoint location
Enabled Check to enable a breakpoint
Note: Buttons displayed will depend on the selected device.
TABLE 11-2: BREAKPOINT DIALOG BUTTONS
Control Function Related Dialog
Add Breakpoint Add a breakpoint Section 11.3.2 “Set Breakpoint
Dialog”
Stopwatch Set up the stopwatch Section 11.3.3 “Stopwatch Dia-
log”
Event Breakpoints Set up break on an event Section 11.3.4 “Event Break-
points Dialog”
Sequenced Breakpoints Set up a sequence until break Section 11.3.5 “Sequenced
Breakpoints Dialog”
ANDED Breakpoints Set up ANDED condition until
break
Section 11.3.6 “AND Dialog”