User manual

Utility-band BPSK 6.0 kbps PLM PICtail™ Plus Daughter Board User’s Guide
DS75019A-page 10 © 2011 Microchip Technology Inc.
The Utility-band BPSK 6.0 kbps PLM PICtail™ Plus Daughter Board is shown in
Figure 1-1. Refer to 2.2 “Hardware Components” for detailed information on the
board components.
FIGURE 1-1: UTILITY-BAND BPSK 6.0 kbps PLM PICtail™ PLUS
DAUGHTER BOARD
1.2 BOARD SETUP
Figure 1-2 illustrates the setup of the daughter board with the Explorer 16 Development
Board. The dsPIC33F Plug-in Module (PIM) and the 9V power supply are plugged into
the Explorer 16 Development Board.
The daughter board is plugged into the PICtail slot of the Explorer 16 Development
Board. The RCA jack of the HV adapter cable is connected to the daughter board. The
AC end of the HV adapter cable is plugged into a mains power outlet. The daughter
board is compatible with 110V/60 Hz mains supply and the 220V/50 Hz mains supply.
Note: If you want to debug or program the software on the dsPIC33F DSC device,
the MPLAB
®
REAL ICE™ in-circuit emulator or ICD3 or PICkit3 should be
connected to the Explorer 16 Development Board.
WARNING
SHOCK HAZARD – Do not open the HV adapter cable enclosure.
Failure to heed this warning could result in bodily harm.