Datasheet

Getting Started
© 2008 Microchip Technology Inc. DS70336A-page 39
3.4.2 Connecting the MPLAB ICD 2 In-Circuit Debugger
1. Connect the MPLAB ICD 2 to the PC using the USB cable.
2. Connect the MPLAB ICD 2 to the 16-bit 28-pin Starter Development Board with
the short RJ-11 (telephone) cable. Apply +9V power to the 16-bit 28-pin Starter
Development Board.
FIGURE 3-15: DAUGHTER BOARD CONNECTED TO MPLAB
®
ICD 2 IN-CIRCUIT DEBUGGER