User manual

Signal Analysis PICtail™ Daughter Board User’s Guide
DS51476A-page 14  2004 Microchip Technology Inc.
2. Connect the PICkit 1 Flash Starter Kit to a PC using a USB cable.
3. Execute the PICkit 1 Signal Analysis PC application.
FIGURE 2-2: PICkit™ 1 SIGNAL ANALYSIS PC APPLICATION INTERFACE
WINDOW
4. Click the PICkit Programmer icon.
5. Open File > Import HEX
from the menu tool bar and select the “PICA2Dlab.hex”
file.
FIGURE 2-3: IMPORT HEX FILE
6. Program the PIC16F684 by selecting the Write Device button.
7. Apply the signal under test to pin RC0. The signal voltage level should be
between 0V and +5V.
PICkit™
Programmer
Oscilloscope
FFT Histogram
Strip
Chart