Datasheet

24AA024H/24LC024H
DS22102A-page 2 © 2008 Microchip Technology Inc.
1.0 ELECTRICAL CHARACTERISTICS
Absolute Maximum Ratings
(†)
VCC.............................................................................................................................................................................6.5V
All inputs and outputs w.r.t. V
SS ......................................................................................................... -0.6V to VCC +1.0V
Storage temperature ...............................................................................................................................-65°C to +150°C
Ambient temperature with power applied................................................................................................-40°C to +125°C
ESD protection on all pins ......................................................................................................................................................≥ 4 kV
TABLE 1-1: DC CHARACTERISTICS
† NOTICE: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the
device. This is a stress rating only and functional operation of the device at those or any other conditions above those
indicated in the operational listings of this specification is not implied. Exposure to maximum rating conditions for
extended periods may affect device reliability.
DC CHARACTERISTICS
Electrical Characteristics:
Industrial (I): VCC = +1.7V to 5.5V TA = -40°C to +85°C
Automotive (E): V
CC = +2.5V to 5.5V TA = -40°C to +125°C
Param.
No.
Sym. Characteristic Min. Max. Units Conditions
D1 — A0, A1, A2, SCL, SDA
and WP pins:
————
D2 V
IH High-level input voltage 0.7 VCC —V—
D3 VIL Low-level input voltage — 0.3 VCC V—
D4 VHYS Hysteresis of Schmitt
Trigger inputs
(SDA, SCL pins)
0.05 VCC —V(Note)
D5 VOL Low-level output voltage — 0.40 V IOL = 3.0 ma @ VCC = 4.5V
I
OL = 2.1 ma @ VCC = 2.5V
D6 ILI Input leakage current — ±1 μAVIN = VSS or VCC, WP = VSS
D7 ILO Output leakage current — ±1 μAVOUT = VSS or VCC
D8 CIN,
C
OUT
Pin capacitance
(all inputs/outputs)
—10pFVCC = 5.0V (Note)
T
A = 25°C, f = 1 MHz
D9 ICC Read Operating current — 400 μAVCC = 5.5V, SCL = 400 kHz
I
CC Write — 3 mA VCC = 5.5V
D10 ICCS Standby current — 1 μAVCC = 5.5V, SCL = SDA = VCC
WP = VSS, A0, A1, A2 = VSS
Note: This parameter is periodically sampled and not 100% tested.