Datasheet

ManualsBrandsMICROCHIP TECHNOLOGY ManualsIntegrated Circuits (ICs)SOIC 8 1 kBit 128 x 8

24C01C

DS21201K-page 2  1997-2012 Microchip Technology Inc.

1.0 ELECTRICAL CHARACTERISTICS

Absolute Maximum Ratings

(†)

VCC.............................................................................................................................................................................7.0V

All inputs and outputs w.r.t. V

SS ......................................................................................................... -0.6V to VCC +1.0V

Storage temperature ...............................................................................................................................-65°C to +150°C

Ambient temperature with power applied................................................................................................-40°C to +125°C

ESD protection on all pins  4kV

TABLE 1-1: DC CHARACTERISTICS

† NOTICE: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the

device. This is a stress rating only and functional operation of the device at these or any other conditions above those

indicated in the operational listings of this specification is not implied. Exposure to Absolute Maximum Rating

conditions for extended periods may affect device reliability.

DC CHARACTERISTICS

Electrical Characteristics:

Industrial (I): VCC = +4.5V to 5.5V TA = -40°C to +85°C

Automotive (E): V

CC = +4.5V to 5.5V TA = -40°C to +125°C

Param.

No.

Sym. Characteristic Min. Max. Units Conditions

D1 — A0, A1, A2, SCL, SDA

and WP pins:

————

D2 V

IH High-level input voltage 0.7 VCC —V—

D3 VIL Low-level input voltage — 0.3 VCC V—

D4 V

HYS Hysteresis of Schmitt

Trigger inputs

(SDA, SCL pins)

0.05 V

CC —V(Note)

D5 VOL Low-level output voltage — 0.40 V IOL = 3.0 mA @ VCC = 4.5V

D6 I

LI Input leakage current — ±1 A VIN = VSS or VCC, WP = VSS

D7 ILO Output leakage current — ±1 AVOUT = VSS or VCC

D8 CIN,

OUT

Pin capacitance

(all inputs/outputs)

—10pFVCC = 5.0V (Note)

A = 25°C, f = 1 MHz

D9 ICC Read Operating current — 1 mA VCC = 5.5V, SCL = 400 kHz

ICC Write — 3 mA VCC = 5.5V

D10 I

CCS Standby current — 5 AVCC = 5.5V, SDA = SCL = VCC

WP = VSS

Note: This parameter is periodically sampled and not 100% tested.