Datasheet

Replace the PCB, making sure that
the line tracker sits into the hole in the
bottom of Edison.
Screw the PCB down with the two
screws towards the back of the board.
If the original screws from your Edison
have become damaged during this
process install the screws provided in
the spare parts pack, using the
provided Allen key.
Place the clear plastic top upside down
on the table and place in the buttons
and IR shield.
Flip Edison over and clip the body onto
the clear plastic top.
Finally, screw in the four screws in each
corner to secure the top and replace the
wheels and plastic skid.