Datasheet

 Spare parts pack
 Needle nose pliers
 Scissors
 Philips head screw driver
Remove the wheels from Edison.
Flip Edison over and remove the tiny
clear plastic skid.
Once those are removed lay the Edison
right side up on the table and remove
the clear top by unscrewing the four
screws located in each corner
Remove the rubber buttons and IR
guard.
Remove the printed circuit board (PCB)
by unscrewing the two screws either
side of the button pads.
Once the circuit board has been placed
to one side, remove the silicone
wedges from the top of the motors (if
your Edison has foam pads leave them
attached).