DVD Recordable Duplication System User's Manual

18
Overburn
The default setting for this feature is OFF. Overburn can be used with certain CD recorders, to
allow more data to be writing to the disc. This feature is not supported by the QD-DVD duplicator.
Read Error Skip
The Read Error Skip feature is used if you wish to ignore read errors during duplication. The
default setting is OFF and it is highly recommended that this setting is not changed. If it is turned
ON, there is the possibility of copying a disc that is not the same as the master.
Burn-in
The Burn-in function is used to test the operation of the QD-DVD duplicator and is for service
purposes only. This function should only be used if directly by Microboards Technical Support.
Update Firmware
The Update Firmware feature is used to update the controller firmware.
1. To update the firmware: Place the firmware CD into the TOP reader drive.
2. Press the ENT button
3. The display will show:
4. Press the ENT button to complete the firmware update.
5. The duplicator will reboot automatically after installing the new firmware.
Compare Firmware
The Compare Firmware function is used to compare the firmware installed on the controller with
the firmware on the CD.
H/W Diagnostic
Hardware Diagnostics runs a number of tests on the controller. Normally this function is used by
service personnel.
Load Default
The Load Default feature will set all the values back to the factory default settings.
ISRC & MCN
The ISRC (International Standard Recording Code) & MCN (Media Catalog Number) feature
allows you to copy this information from a CD audio master to the blank disc. The default setting
if OFF.
Switch USB Mode
The Switch USB Mode allows you to enable or disable the ability to use the QD-DVD recorder
drive as an external burner for your PC. Selecting ON will allow access to the USB Mode menu,
which will appear as menu item 10. Selecting OFF will hide the option in the main menu.
The QD-DVD cannot use any function while operating in USB Mode.
Update F/W A.ABC
To A.XYZ YES?