Specifications

MICROBOARDS TECHNOLOGY, LLC PF-PRO Disc Printer
9
PF-Pro Disc Printer Installation
The PF-Pro Disc Printer installation disc includes an Installer that will walk you
through the process step by step. Please use the Installer and follow the
installation steps in order.
The following installation sections are intended only as a reference for the installation process, not as
a guide to installing the PF-Pro Disc Printer. Performing the installation out of order could result in an
unsuccessful installation.
The PF-Pro Disc Printer Installation Quick Reference Guide will show you the order in which the
installation will occur.
Installation should always be done when logged in as a user with full Administrator rights.
Connecting to a PC
DO NOT CONNECT YOUR PF-Pro DISC PRINTER TO A COMPUTER BEFORE
RUNNING THE INSTALLER LOCATED ON THE INSTALLATION DISC!!
The connection between the PC and the Microboards PF-Pro Disc Printer is done with one USB
cable.
1. Confirm that the power is turned OFF on the PF-Pro Disc Printer and on your PC.
2. Plug in the AC power cord to the back of the PF-Pro Disc Printer. Do not turn on power to
the PF-Pro Disc Printer until all 4 ink cartridges and both printheads have been installed.
3. Connect the square shaped end of the USB cable to the back of the PF-Pro Disc Printer.
4. Connect the flat, rectangular end of the USB cable into a USB 2.0 port in
your PC.
USB Cable length exceeding 6 feet between the PF-Pro Disc
Printer and the PC is not supported!