Specifications

MICROBOARDS TECHNOLOGY, LLC GX AUTO PRINTER
11
Figure 2
Figure 1
Setting Printer Alignment
Alignment
The GX Auto Printer system has been aligned at the factory. The factory alignment values are on a
label on the back of the GX Auto Printer. Follow these steps to enter the factory values:
• Click on the Start Button on your
Windows computer.
• Select Settings and then
Printers.
• Right click on the Microboards
GX Series icon.
• Select Printing Preferences.
• Select the Utility Tab.
• Click on the .1mm selection in
the Resolution box.
• Enter the values listed with the
GX Auto Printer into the Top and
Left Side boxes.
• Click the Apply button.
• Click the OK button.
• Verify the alignment by printing
an Alignment Disc.
Print Alignment Disc
NOTE: The Alignment Disc should always be printed using
Photo mode for the best accuracy.
1. Place an Alignment CD (see figure 1) in the input bin.
2. Double-click the desktop icon for the Microboards GX
Toolbox
3. Click the Print Alignment Disc button.
4. The alignment guide will be printed on the disc (see figure
2).
5. Confirm the numbers that cross the circle.
6. If the circle does not cross the alignment guide at both zero
points, change the vertical and horizontal numbers in the
Utility Tab by the number at which the circle does cross the
guide.
7. Once the new numbers are entered, click Apply.
8. The Alignment CD pattern is also included on the GX Auto
Printer CD, so you can print additional Alignment patterns
with your GX Auto Printer, once it is aligned. The
alignment circle is 8 cm in diameter and is 2 cm from the
outer edge of the CD.