Specifications

MICROBOARDS TECHNOLOGY, LLC G3 Auto Printer
11
Docked
Utility Icon
Microboards Utility
Access the Microboards Utility by selecting the System Preferences from the Dock.
Select Print & Fax. Highlight the Microboards GX Series icon and click the Utility
icon. You can also select Open Printer Utility from the Utilities menu in PrintWrite.
The Utility will allow you to access the Printer information as shown below.
Supply Status
The Supply Status page shows how much remains of all 3
colors, Cyan, Magenta and Yellow.
NOTE: If you place a used cartridge in the G3, the ink level
may not be reported correctly. If the G3 can identify the
cartridge, it may report the correct ink levels; if not, it will
assume that the ink cartridge is new and will show ink levels
of 100%.
Before each disc is printed, the ink levels are checked. If the
level of any one color is has reached 10%, a warning
message will be displayed on your Mac and printing will be
temporarily suspended. You can either change the cartridge
at this point, or continue printing using the same cartridge.
If you continue with the same cartridge, printing will continue
uninterrupted until the ink level reaches 5%. The low ink level
warning will be displayed once more. Again, either change the cartridge or continue.
Once the ink level reaches 3% or less, the warning will be displayed before each print.
It is strongly recommended that you replace the cartridge at this point.
Clean Pen
The Clean Pen function allows you to run a cleaning cycle on
the ink cartridge.
At least one disc must be in the input hopper for the utility to
function.
Click the Clean button once a disc has been loaded to the belts.
If the resulting disc shows streaks similar to those shown in the
image on this page, you may need to run the Clean utility again.