Specifications

MICROBOARDS TECHNOLOGY, LLC G3 AUTO PRINTER
9
G3 Auto Printer Installation
The G3 Auto Printer installation disk includes an Installer that will walk you
through the process step by step. Please use the Installer and follow the
installation steps in order.
The following installation sections are intended only as a reference for the installation process, not as
a guide to installing the G3 Auto Printer. Performing the installation out of order could result in an
unsuccessful installation.
Installation should always be done when logged in as a user with full Administrator rights.
Connecting to a PC
DO NOT CONNECT YOUR G3 AUTO PRINTER TO A COMPUTER BEFORE RUNNING
THE INSTALLER LOCATED ON THE INSTALLATION DISK!!
The connection between the PC and the Microboards G3 Auto Printer is done with one USB cable.
1. Plug in the AC power cord to the back of the G3 Auto Printer.
2. Confirm that the power is turned ON to both the G3 Auto Printer and on your PC.
3. Connect the square shaped end of the USB cable to the back of the G3 Auto Printer.
4. Connect the flat, rectangular end of the USB cable into a USB 2.0 port in
your PC.
5. Turn on the G3 Auto Printer.
USB Cable length exceeding 6 feet between the G3 Auto Printer
and the PC is not supported!
Windows 7 and Vista Hardware Installation
The Microboards G3 Auto Printer Installer should always be run when logged in as user with full
Administrator rights. This is required for the driver pre-installation to be successful. Once the G3
Auto Printer is plugged into the PC via the USB connection, the hardware will automatically be found
and installed on your PC.
During the driver pre-installation, you may need to verify that you would like to install the drivers.
If the Installer is run by a user without full Administrator rights, or you do not verify that the drivers
should be installed, the hardware will need to be installed using the Hardware Wizard. Please follow
the directions below.