Specifications
• Assembly and Ink Installation
8
Power Button
Cancel Button
Ink Light
Media Light
Power/Activity
Light
Loading Discs
The next step is to load your G3 Auto Printer with discs. The system will accept CD or DVD 120 mm
(12 cm) inkjet printable discs. If the disc does not have an inkjet printable surface, the ink will not
adhere to the surface of the disc. The G3 Auto Printer will only accept 12 cm discs. Business card or
8 cm discs are not supported by this system.
Figure 1 Figure 2
Load the first 5 or 6 discs flat, as seen in figure 1.
Load the rest of the discs at an angle, against the wide input rod, as seen in figure 2.
The G3 Auto Printer will hold a maximum of 50 discs. DO NOT load more than 50 discs in the
system, as this may cause the discs to feed incorrectly.
Front Control Panel
The AC power switch located on the back of the G3 Auto Printer must be turned on first in order to
supply power to the Front Control Panel.
The Power Button on the front panel of the G3 Auto Printer turns the Printer on and off. It may take
a few seconds for the Printer to turn on after you press the Power Button.
To turn off the power to the printer using the Control Panel, you will need to press and hold the Power
Button for 3 seconds. Once the Ink Light, Media Light, and Power Light begin flashing, you can
release the Power Button.
The green Power/Activity light flashes when the printer is active, either while printing or initializing.
The Cancel Button can be used
to discontinue printing. This will
either cancel the entire print job or
just the current disc, depending on
the label being printed.
If a disc is not detected during
printing, the Media Light will
flash. Verify that you have discs
in the input hopper and press the
Media Light to load and print the
next disc.
The Ink Light will come on if the
ink cartridge is low or empty.
Output Bin Sensor
The G3 Auto Printer is equipped with an output bin sensor to warn you when the output bin is full. If
the bin is full, the Media Light will stay on and you will not be able to print another disc until the bin is
emptied.