Specifications

• G3 Auto Printer Installation
12
Setting Printer Alignment
Alignment
The G3 Auto Printer has been aligned to 0.1mm precision at the factory. You may need to fine tune
the alignment settings for full surface coverage depending on the media brand and print surface type.
Follow these steps if alignment modification is needed:
• Click on the Start Button on your Windows computer.
• Select Settings and then Printers.
• Right click the Microboards G Series icon.
• Select Printing
Preferences.
• Select the Alignment
Tab.
• Click on the .1mm
selection in the
Resolution box.
• Enter the alignment
changes into the Top
and Left Side boxes,
using the graphic
instructions on the right
side as a guide to
moving the print image
on the disc.
• Click the Apply button.
• Click the OK button.
• Verify the alignment by printing full coverage image created in SureThing. The image should
print centered on the disc. If not, adjust the Top and Left Side alignment values according to
the graphic on the Alignment tab and repeat.
G3 Toolbox
A shortcut to the G3 Toolbox was added to your desktop during the printer installation.
Double-click the icon to open the toolbox. For each of the functions, a blank disc will need
to be loaded.
Print Test Disc
Load an unprinted disc in the input hopper prior to clicking this button to print a Test Disc image.
Exercise Belt
This utility should be run if the printer has been idle for an extended period of time, and can be run
multiple times if necessary. The belts will run at high speed for a period of time to recondition the
belts. It is not necessary to load any media for this utility.
Cleaning
The printheads may require cleaning if the printed images show streaks of color. This may occur if
the G3 Auto Printer has been idle for an extended period of time.
You will need to place a disc on the belts below the input hopper prior to running the Cleaning.
Running this process more than once may be required if the quality does not improve after cleaning
one time.