User`s manual

3
Setting up the CopyWriter Tower duplicator
Set up the CopyWriter Tower duplicator with
the following conditions:
•
On a level and stable surface
•
In a well ventilated location
•
Temperature and humidity:
o Temperature: 5-40°
o Humidity: 20-80%RH (no dew formation)
Do not locate the CopyWriter Tower duplicator:

Under direct sunlight (If the machine is exposed to sunlight, the light should be blocked by a curtain
or blind.)

In a place where there is a lot of vibration

Near open flame

In a place where the temperature and humidity change drastically

Near a heating device such as a heater or furnace

In a location where air from an air conditioner blows directly onto the unit

Near a container filled with water such as a vase

In a dusty location
o
Dust and dirt can decrease the productivity of the duplicator dramatically. It is very
important to keep the system in a clean and dust free environment.
In winter during times of low humidity or in a location where static electricity is
generated, use an anti-static-electricity mat or humidifier to prevent static electricity
.
Copy Process
The advantage of the COPYWRITER TOWER DUPLICATOR is the quick and easy operation to burn
CD information. You can burn CD-R’s by pressing the button only once with the COPYWRITER
TOWER DUPLICATOR as follows;
 Connect the power cable to the back of the COPYWRITER TOWER unit and connect to a power
source.
 Turn on COPYWRITER TOWER DUPLICATOR, and it begins to initialize.
o The LED’s turn on, one at a time and then go off, leaving only the copy button on.
o Insert a Master disc into the Master drive and blank discs into writers.
o Wait for ten seconds until the drives are ready.
o Press the ‘START’ button (press it once).
o The copy process begins.
Refer to the “LED’s Status” and “Copy Mode Process” sections for details.