User`s manual

Compact Flash Duplicator
15
Appendix 1: List of Functions
1 Copy
2 Async Copy
3 Compare
4 Copy & Compare
5 Erase
6 Copy Mode
7 Setup
7.1 Language (default is English)
7.2 Read Error Skip
7.3 Write Error Skip
7.4 Size Tolerance
7.5 Buzzer
7.6 Screen Saver
8 Utilities
8.1 Device Info
8.2 System Info
8.3 Measure Speed
8.4 Verify Source
8.5 Rebuild Source
8.6 Load Default
8.7 Update Firmware
8.8 Save
9 Manage Accounts
9.1 View User
9.2 Create User
9.3 Delete User
9.4 Password On Bootup
10 Shutdown
Appendix 2: LED Indicators
Each port on the Duplicator has 2 LEDs above the port to indicate the current state of the flash
device currently inserted into each port. The states are as follows:
No LED
No device is inserted, or the inserted device is not recognized. For SD and
MicroSD cards, you may have the card in the port upside-down; flip the card
over and try again.
Solid Green
A flash device has been inserted into the port and recognized, but is currently
idle.
Flashing Green
The flash device is being accessed, either writing to the device or reading
from the device.
Solid Green
and Solid Red
Duplication is complete and the flash device is ready to be removed.
This LED state only occurs during Async Copy.
Solid Red
The flash device in the port did not duplicate correctly, or differences were
found between the copy and the master during a Compare.