User manual

USER MANUAL
m crob t
RRC-1258 MKII
mickes-reviderade- Ba1258B_RemoteRig_MkIIs-PA5.docx
Microbit 2.0 AB 2010. All rights reserved
User manual
Rev. PA8 – 23 Jan 2011
78 of 146
ICOM IC-R2500
General
The technical solution is the same as for IC-706 and TS-480; you can remote control the
receiver over Internet from the control panel without any PC. We simply replace the cable
between the control panel and the receiver with two RRC-1258 units, one at the control panel
and one at the receiver. When you push the PWR-ON button an audio and data connection is
established between the units and you control the receiver as you do normally with the
control panel attached directly to the receiver.
Hardware configuration
Radio settings (example)
Parameter
Control
Radio
Program mode
7 – ICR2500
7 – ICR2500
SIP password
hello
hello
SIP realm
SIP contact
192.168.0.228
Auto connect
No
Audio quality
2 – Linear 16 bits 8 kHz
2 – Linear 16 bits 8 kHz
Audio dual-rx (*)
No/Yes
Codec out gain
255
255
Codec inp gain
18
0
Codec inp preamp
Yes
Codec inp HPF Hz
163
163
COM0 baudrate
9600
9600
COM0 data bits
8
8
COM0 stop bits
1
1
COM0 parity
0 - Off
0 - Off
(*) Available only in RRC-1258MkIIs, remember that the bandwidth demand is doubled.