User manual

USER MANUAL
m crob t
RRC-1258 MKII
mickes-reviderade- Ba1258B_RemoteRig_MkIIs-PA5.docx
Microbit 2.0 AB 2010. All rights reserved
User manual
Rev. PA8 – 23 Jan 2011
44 of 146
COM1 baudrate
Set COM1 baudrate [bps]:
1200
2400
4800
9600 (default)
19200
38400
57600
COM1 databits
Set COM1 data bits:
5
6
7
8 (default)
COM1 stop bits
Set COM1 stop bits:
1 (default)
2
COM1 parity
Set COM1 parity:
0 = Off (default)
1 = Odd
2 = Even
3 = Forced-1
4 = Forced-0
COM1 cts/rts
Enable the transfer of CTS input to RTS output of
other RRC.
0 = No (default)
1 = Yes
COM1 terminator
Defines the terminator character used in COM1-
mode=5 (user-def-terminator). Character should be
in HEX-format.
00 (default)
COM2 mode
Select mode for COM2-to-COM2 transparent transfer
of serial data between two opposite RRC. The setting
defines the event that triggers the data transfer over
Internet.
- Inactive (default)
- Logical parallel with COM0. Is used for level
converting for CI-V and FT-8x7. The settings
from “Radio settings” are used.
- Char-by-char. A data packet is send for each
char, needs lot of bandwidth.
- ICOM CI-V. Used for CI-V control of IC-703/706
at the same time as you use the control panel.
- Char-timeout. A data packet is sent when there is
a pre-defined pause between two received char.
- Kenwood, Yaesu, Elecraft. Used for CAT control of
TS-480 or TS-2000 at the same time as you use
the control panel.
- User-def-terminator. Used if you want to define
the terminator char by yourself (see below).
COM2 databits
See COM1
COM2 stop bits
See COM1