User manual

USER MANUAL
m crob t
RRC-1258 MKII
mickes-reviderade- Ba1258B_RemoteRig_MkIIs-PA5.docx
Microbit 2.0 AB 2010. All rights reserved
User manual
Rev. PA8 – 23 Jan 2011
43 of 146
Parameter
Setting
COM1 mode
Select mode for COM1-to-COM1 transparent transfer
of serial data between two opposite RRC. The setting
defines the event that triggers the data transfer over
Internet.
- Inactive (default)
- Char-by-char. A data packet is send for each
char, needs lot of bandwidth.
- ICOM CI-V. Used for CI-V control of IC-703/706
at the same time as you use the control panel.
- Char-timeout. A data packet is sent when there is
a pre-defined pause between two received char.
- Kenwood, Yaesu, Elecraft. Used for CAT control of
TS-480 or TS-2000 at the same time as you use
the control panel.
- User-def-terminator. Used if you want to define
the terminator char by yourself (see below).