User manual

USER MANUAL
m crob t
RRC-1258 MKII
mickes-reviderade- Ba1258B_RemoteRig_MkIIs-PA5.docx
Microbit 2.0 AB 2010. All rights reserved
User manual
Rev. PA8 – 23 Jan 2011
42 of 146
Serial Settings
The serial ports COM1 and COM2 can be used as a transparent serial channel between
Control-RRC and Radio-RRC over Internet. The COM-ports can be used for CAT control,
rotator control etc. COM1 is always free to be used with the drawback that you cannot use
COM1 for configuration. COM2 is used for the radio control in some of the program modes and
can then not be used as a transparent serial channel.
Radio settings /
Program mode
COM1
free channel
COM2
free channel
0 - Transparent
yes
yes
1 - ICOM CI-V
yes
no
2 – IC706
yes
yes
3 – FT-8x7, FT-1000x
yes
no
4 – Yaesu, Kenwood, Elecraft
yes
no
5 – TS480/TM-D710
yes
yes
6 –
(*)
yes
yes
7 – IC-R2500
yes
yes
8 – TS2000
yes
yes
9 – IC-2820
yes
yes
10 – Yeasu FT-950/FT-2000
/FT-5000/FT-9000 Twin
yes
no
11 – Transparent, 4-wire(*1)
yes
yes
12 – DX-SR8
yes
yes
COM1 and COM2 mode can be configured differently depending on what they will be used for.
The same settings must be done in both Control-RRC and Radio-RRC.
(*1) = Need special hardware