User manual

USER MANUAL
m crob t
RRC-1258 MKII
mickes-reviderade- Ba1258B_RemoteRig_MkIIs-PA5.docx
Microbit 2.0 AB 2010. All rights reserved
User manual
Rev. PA8 – 23 Jan 2011
39 of 146
Program mode
Select the program mode depending on connected
radio:
0 = Transparent (for repeater links etc.)
1 = ICOM CI-V (generic)
2 = IC706 (with detached control panel)
3 = FT-8x7, FT-1000
4 = Kenwood, Yaesu, Elecraft
5 = TS480/TM-D-710 (with detached control panel)
6 =
(*1)
7 = IC-R2500 (with detached control panel)
8 = TS2000 (with RC-2000 control panel)
9 = IC-2820
10 = Yeasu FT-950/FT-2000/FT-5000/…. Twin
(*2)
11 = Transparent, 4-wire (for repeater links etc.)
12 = DX-SR8
(*1)
These selections are only possible in special
editions of the RRC.
(*2)
Only available in the Yaesu Twin version.
Sip password
Protect your remote rig and should be same in both
ends.
(default: no password)
Sip contact
Control-RRC:
Sets the fixed IP address or the DynDNS host name
to the Radio-RRC
Auto connect
Control-RRC:
When enabled the Control-RRC will connect to
Radio-RRC immediately after power up in program
mode 0, 1, 3 and 4.
No (default)
Yes
Sip realm
Radio-RRC:
Not used yet.
Audio quality
Sets the audio quality depending on available
bandwidth. Sample rate must be same in both RRC
but coding can be different (more information can
be found in appendix-A Audio coding):
0 = A-law 8 kHz
1 = Linear 12 bits 8 kHz
2 = Linear 16 bits 8 kHz (default)
3 = A-law 12 kHz
4 = Linear 12 bits 12 kHz
5 = Linear 16 bits 12 kHz
6 = A-law 16 kHz
7 = Linear 12 bits 16 kHz
8 = Linear 16 bits 16 kHz
9 = A-law 24 kHz
10 = Linear 12 bits 24 kHz
11 = Linear 16 bits 24 kHz
12 = IMA ADPCM 4 bits 8 kHz
12 = IMA ADPCM 4 bits 16 kHz