User manual

USER MANUAL
m crob t
RRC-1258 MKII
mickes-reviderade- Ba1258B_RemoteRig_MkIIs-PA5.docx
Microbit 2.0 AB 2010. All rights reserved
User manual
Rev. PA8 – 23 Jan 2011
35 of 146
Parameter
Setting
Unit ID (Banner)
Text, whatever you want, that will be shown at the
top of the web-page (within brackets). Used to
identify different RRC.
“empty” (default)
“text”
DHCP
Select between a fixed IP address and DHCP. DHCP
can be practical for the Control-RRC but fixed IP
address is preferred in Radio-RRC.
No (default)
Yes
IP
IP-address (only when fixed IP-address is used)
192.168.0.227 (default Control-RRC)
192.168.0.228 (default Radio-RRC)
nnn.nnn.nnn.nnn
Netmask
Net mask (only when fixed IP-address is used)
255.255.255.0 (default)
nnn.nnn.nnn.nnn
Gateway
Gateway (only when fixed IP-address is used)
192.168.0.1 (default)
nnn.nnn.nnn.nnn
Dns server
DNS-address (only when fixed IP-address is used)
192.168.0.1 (default)
nnn.nnn.nnn.nnn
Extern IP/Host
Fixed external IP-address of your NAT-router. Should
NOT be used in normal installations.
“empty” (default)
nnn.nnn.nnn.nnn
Eth-type
Type of Ethernet connection:
Auto
Auto, prefer 10 Mbit (default)
10HDX*
10FDX*
100HDX*
100FDX*
Auto prefer 10 Mbit is default as more speed is not
needed and the emissions from a 10 Mbit LAN is
much less than from a 100 Mbit LAN
(*) If you use fixed settings you must have a
managed switch where you can set the same
setting.