User manual

USER MANUAL
m crob t
RRC-1258 MKII
mickes-reviderade- Ba1258B_RemoteRig_MkIIs-PA5.docx
Microbit 2.0 AB 2010. All rights reserved
User manual
Rev. PA8 – 23 Jan 2011
27 of 146
The Netmask is 255.255.255.0 the Netmask in the RRC:s should be the same
The Default gateway is 192.168.0.1 the Gateway in the RRC:s should be the same
In this case all the default IP setting will be OK.
In an other network, this is the result of the ipconfig command.
Your PC IP address in this example is 192.168.128.10 this means that the IP of the RRC:s
must have IP:s in the area 192.168.128.2 to 192.128.255.
The Netmask is 255.255.128.0 this the Netmask in the RRC:S should be the same
The Default gateway is 192.16.128.1 the Gateway in the RRC:S should be the same
In this case you must change the IP:s of the RRC. I recommend to use 192.168.128.227 and
192.168.128.228
Use the Microbit Setup Manager to change the IP settings.
Select the Setup tab click on the “Get Setup” button and enter the IP addresses in the Setup
info dialog box.