User manual

USER MANUAL

m crob t

RRC-1258 MKII

mickes-reviderade- Ba1258B_RemoteRig_MkIIs-PA5.docx

User manual

Rev. PA8 – 23 Jan 2011

25 of 146

Click on the "Select file" button and browse to the file with the new firmware, it should be

something like “RRC-1258-CRC_v1.46_2009-11-26.bin” depending on the version and release

date. When you have selected the file click on the "Update" button and the update process

will start, the text in the bottom field will change to "Updating firmware". Attention -- Do not

interrupt the update process in any way!

After about a 1 minute the update is finished and the RRC will restart. When the text "RRC-

connected" shows up again in the lower field of the RRC-Manager, you can change to the

"FW/HW" tab and check software version.

Setup

A new window wills pop-up with the basic IP settings. Change the settings so they fit into your

local network and press the "Save" button to save the new settings. The RRC will restart

again and when the text "RRC-connected" shows up again in the lower field of the RRC-

Manager, you can click on the "Setup" button again to verify the changes.

Net info

Click on the “Get” button to read the IP setting currently in use by the RRC.