User manual

USER MANUAL

m crob t

RRC-1258 MKII

mickes-reviderade- Ba1258B_RemoteRig_MkIIs-PA5.docx

User manual

Rev. PA8 – 23 Jan 2011

23 of 146

Configuration with Microbit Setup Manager

The initial settings of the network parameters are easiest done with the RRC-Manager. The

RRC-Manager is a software which runs under Windows on a PC and connects to the RRC via

USB (an USB cable is supplied with the RRC). RRC-Manager can be used for:

IP Settings and verification

o IP-address

o Netmask

o Gateway

o DHCP

Firmware upgrade

o Application

o Bootloader

Start with downloading the RRC-Manager from the homepage www.remoterig.com. Install the

RRC-Manager by following the instructions which shows up. If you have an older Windows

version where Netframework 2.0 is not installed, the installer will guide you through the

installation of Netframework. When you have finished the installation a new shortcut to RRC-

Manager will show up on the desktop. Click on the icon to start RRC-Manager

Connect your RRC to 12V and connect the USB-cable between your computer and the USB

jack on the front of the RRC. Windows will automatically install the necessary drivers. When

it's done the text in the bottom field will change from "RRC not connected" to "RRC-

connected" which is an indication that you are in connection with the unit.