User manual

USER MANUAL
m crob t
RRC-1258 MKII
mickes-reviderade- Ba1258B_RemoteRig_MkIIs-PA5.docx
Microbit 2.0 AB 2010. All rights reserved
User manual
Rev. PA8 – 23 Jan 2011
126 of 146
Radio-RRC:
From the RRC COM2 connector to the radios KIO3 module connector (D-sub RS-232) you
use a standard RS-232 cable.
Between the RRC AUX/MIC connector and the radios circular microphone jack you need to
make an adapter cable by yourself or buy one from e.g. a Tigertronics distributor (for
Signallink), its article number is SLCAB8R. If you use Tigertronic cable you need to put the
straps different. If you make the cable by yourself, just cut a standard FTP (screened)
patch cable and solder an 8-pin circular connector on it. Make the cable as short as
possible to prevent it from picking up HF.
The speaker signal from the radios external speaker jack to the RRC SP jack is connected
via a standard "off- the-shelf” cable with 3.5 mm stereo plugs in both ends.