User manual

USER MANUAL
m crob t
RRC-1258 MKII
mickes-reviderade- Ba1258B_RemoteRig_MkIIs-PA5.docx
Microbit 2.0 AB 2010. All rights reserved
User manual
Rev. PA8 – 23 Jan 2011
12 of 146
7
CTS (In)
8
RTS (Out)
9
AUX/MIC
The AUC/MIC connector (RJ-45) is used for microphone connection or for connection of the
radio control panel (IC-703/706, DX-SR8). Inside the RRC behind the connector is a set of
straps with can be used to decide how the connector should be configured depending on radio
or microphone. The red and yellow LED:s are indicating SIP-status:
LED
LED Red
LED Yellow
Off
Incoming audio stream OK
SIP disconnected
Flashing
-
SIP connection failed
On
Incoming audio stream fail
SIP connection OK
Pin no
AUX (RJ45)
1
depends on the inside straps
2
depends on the inside straps
3
depends on the inside straps
4
depends on the inside straps
5
depends on the inside straps
6
depends on the inside straps
7
depends on the inside straps
8
depends on the inside straps
TTL Control-RRC
The TTL connector on Control-RRC (RJ-12) is used primary for connection of the radio control
panel (TS-480, RC-2000 and IC-E2820) and in other cases where you need to connect via a
TTL level (5V) port. The connector is configured so a straight cable can be used to a TS-480
and RC-2000 control panel.