User manual

USER MANUAL
m crob t
RRC-1258 MKII
mickes-reviderade- Ba1258B_RemoteRig_MkIIs-PA5.docx
Microbit 2.0 AB 2010. All rights reserved
User manual
Rev. PA8 – 23 Jan 2011
110 of 146
Configuration type 2:
Radio settings (example)
Parameter
Control
Radio
Program mode
5 – TS480/TM-D710
5 – TS480/TM-D710
SIP password
hello
hello
SIP realm
SIP contact
192.168.0.228
Auto connect
No
Audio quality
2 – Linear 16 bits 8 kHz
2 – Linear 16 bits 8 kHz
Audio dual-rx (*)
No
Codec out gain
255
255
Codec inp gain
13
0
Codec inp preamp
Yes
Codec HPF Hz
163
163
COM0 baudrate
57600
57600
COM0 data bits
8
8
COM0 stop bits
1
1
COM0 parity
0 - Off
0 - Off
*) Available only in RRC-1258MkIIs.
Connections
All necessary signals between the panel and the radio are connected with the 6 wires in the
connection cable. We just need to cut it apart and connect a RRC-1258MkII in each end.
Convenient for travelling is that the speaker is already present on the back of the control
panel so there is no need for an extra speaker, even if a separate speaker gives a much
better audio. The following signals are represented in the connection cable (6-pol modular):
1 SPK GND - speaker ground
2 8V power to control panel (always present)
3 GND