User manual

USER MANUAL

m crob t

RRC-1258 MKII

mickes-reviderade- Ba1258B_RemoteRig_MkIIs-PA5.docx

User manual

Rev. PA8 – 23 Jan 2011

11 of 146

Hardware

Front

PWR LED

Green light is indicating normal status. When the green LED is flashing the unit is trying to

connect to the Ethernet, normally it only takes a few seconds. If the LED do not end flashing

it's probably something wrong with the network connection.

USB

The USB-interface is used to initially set up the IP parameters. It can also be used for

downloading new software (can also be done via the WEB-interface). At the Control-RRC it

can also be used for PTT or CW control via the RTS and DTR signals in the virtual COM-port

delivered by the RRC USB device.

COM1

COM1 can in special cases be used to set parameters and check statuses if USB or WEB

cannot be used. The COM1 port can also be used for ex. rotator control as it can be

configured as transparent serial port between the RRC:s.

RS-232

Pin no

RS-232 Interface (9-pol D-sub female)

TXD (Out)

RXD (in)

GND