User manual

USER MANUAL

m crob t

AS-1289

Ba-AS1289-PA1 (reparerad)

User manual

Rev. PA1 – 2014 feb 17

45 of 46

Appendix E - Safety and Regulatory Information

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

 This device may not cause harmful interference.

 This device must accept any interference received, including interference that may

cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modification not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

Safety Notice

 Do not use this product near water, for example, in a wet basement or near a

swimming pool.

 Avoid using this product during an electrical storm. There may be a remote risk of

electric shock from lightning.

 Warning: Never operate this device with a headset or other audio accessories at high

volume levels. Hearing expert’s advice against continuous high volume operation, if

you experience a ringing in your ears, reduce the volume level or discontinue use.

 Never connect a power supply of more than 18 VDC to the power jack. The supply

voltage must be between 10 V and 18 V. to prevent damaging the device.