User manual

USER MANUAL
m crob t
AS-1289
Ba-AS1289-PA1 (reparerad)
 Microbit 2.0 AB 2010. All rights reserved
a
User manual
Rev. PA1 – 2014 feb 17
19 of 46
Configuration with WEB-interface
Before you can use your Antenna switch AS-1289 you must configure it. The unit will have the
default IP addresses 192.168.0.236. The net mask is 255.255.255.0. The configuration is
easiest done via the web interface. Be aware of that your PC must be in the same net e.g.
having an IP-number between 192.168.0.2 and 192.168.0.254 and not be the same as the
AS-1289. If the default IP-address of the Antenna Switch do not fit your network please use
the PC-program Microbit Setup Manager to change the IP-addresses via USB.
Select setup page from the links on the left side and edit the parameters. After each setup
pages is finished press Submit to temporary store the new settings. When you do that a new
red Apply changes button appears on the pages. You can now change parameters on other
pages but the new settings will not take effect until you press Apply changes. When you do that
the unit will reboot and start up with the new settings. If you change your mind after clicking
on submit you can click on Restart device on the left to restart the device without changing
any settings.