User manual

USER MANUAL
m crob t
AS-1289
Ba-AS1289-PA1 (reparerad)
 Microbit 2.0 AB 2010. All rights reserved
a
User manual
Rev. PA1 – 2014 feb 17
10 of 46
Configuration with Microbit Setup Manager
The initial settings of the network parameters are easiest done with the Microbit Setup
Manager. The Setup Manager is a software which runs under Windows on a PC and connects
to the RC via USB (an USB cable is supplied with the AS-1289).The Setup Manager can be
used for:
 IP Settings and verification
o IP-address
o Netmask
o Gateway
o DNS
o DHCP
 Firmware upgrade
o Application
o Bootloader
o Factory default reset
Start with downloading the Microbit Setup Manager from the homepage www.remoterig.com.
Install the Setup Manager by following the instructions which shows up. If you have an older
Windows version where Netframework 2.0 is not installed, the installer will guide you through
the installation of Netframework. When you have finished the installation a new shortcut to
Microbit Setup Manager will show up on the desktop. Click on the icon to start Microbit Setup
Manager
Connect your AS1289 to 12V and connect the USB-cable between your computer and the USB
jack on the AS1289. Windows will automatically install the necessary drivers. When it's done
the text in the bottom field will change from "Device not connected" to "Device connected"
which is an indication that you are in connection with the unit.