User Manual
8
USER MANUAL
CONTROL MENUS
eGive: Use the Left and Right buttons to select level. Level 0 = Disabled,
Level 1 = Low Give, Level 2 = Medium Give, Level 3 = High Give. When changing
eGive level, please allow machine to nish sensing needle before using.
Killswitch: On/Off select with Left/Right buttons. Once turned on, you must tap
Killswitch to establish connection. If Killswitch is not activated the menu will remain
on screen for 90 sec before reverting to off mode. Once activated the Killswitch will
remain connected until user disconnects it in the Killswitch mode menu.
Timer: Start/Stop select with Right/Left buttons. The timer runs from 0-24 Hrs
in one minute intervals. Once timer is stopped, it resets back to zero.
Display Mode: Use Left/Right buttons to select Voltage or Hertz as main power
display.
Needle Detector: Use Left/Right buttons to select on or off. eGive must be set
to at least 1 to function. When active, needle detection compliments the eGive
function for improved response.
Screen Orientation: Use Left/Right buttons to select left or right hand operation.
Travel Mode: Use Left/Right buttons to select Cancel/Off. Cancel: Clears the
menu. Off: Deactivates the battery. To reactivate Bellar Air battery, plug in the
USB-C cable.
OLED Display
Main Power Display
(Hertz or Volts)
Battery charge
Indicator
Bluetooth
Indicator
Secondary Power
Display (Hertz or Volts)
eGive Level Timer
Voltage Up
Power Button
Voltage Down
Battery Charge: 4 bars = 100%, 3 bars = 75%, 2 bars = 50% and 1 bar = 25%.
Single bar will blink to indicate when there is approximately 15% left of power.
Note: Screen will switch to sleep mode after 15 seconds when machine not in use.
Press the power button to wake.
Charging: When USB-C is plugged in, screen mode will show battery charging.
For best results, use provided charging cable.
Device Reset: Hold the Up and Down buttons at the same time.
Modes Menu: Hold the center button to navigate built-in menu. Keep holding to cycle through
menu. Release to stay on a chosen screen and select with Left/Right buttons. After releasing
the center button, you can also tap it again for the next menu screen.