User Manual
12
USER MANUAL
VOLTAGE PARAMETERS
While voltage is a parameter that will vary from artist to artist, this machine has been tested
to operate at a minimum voltage of 4 Volts and a maximum voltage of 10 Volts.
Depending on the type of needle conguration or brand you use, feel free to adjust the voltage to
obtain the desired performance.
ACCEPTED NEEDLES
Use only cartridge needles with an internal membrane. This will avoid accidental contamination
inside your machine. Fluids such as ink, water or oil will void warranty of the device and may require
replacement of internal parts.
MAINTENANCE
• Bellar Air is sold pre-lubricated from the factory and does not need internal lubrication.
• Prevent any type of external elements from entering inside the machine as they will disrupt the
motion of the component and contaminate lubrication.
• The grip of the machine is autoclavable. Use only steam autoclaves at temperatures no higher
than 270° Fahrenheit or 132.222° Celsius. Add a hint of ointment or PTFE grease around internal
opening of grip or on stabilizing friction O-rings for optimal functionality after autoclaving. Refer
to page 5 for additional information.
• Machine Body and Battery can be sanitized from the outside with cold sterilization products.
• Never spray the surface directly to prevent uids from entering the machine. Always use pads or
disposable paper towels to apply sterilization products.
• DO NOT DISASSEMBLE MACHINE.
WARRANTY
• All the housing components (Grip, Machine Body and Battery) are covered by a
lifetime warranty.
• Internal parts are subject to wear and the motor itself will be covered by a 1 year warranty from
the date of purchase.
• Motor warranty is void if motor shows signs of being dropped, of internal uids entering the
motor, and/or IF motor shows signs of being tampered in any way.
ADDITIONAL INFORMATION