User`s manual

High Performance Low Cost Embedded Systems
You can browse the directories and files in the system via this browser.
Note: Qtopia-2.2.0 doesn’t have a file browser, FriendlyARM migrated one from Qtopia-1.7.0.
They have the same functions and interface.
3.1.10 Configuring Network
In the “FriendlyARM” subgroup, click on the “Network Settings” icon:
From this interface we can set various network parameters:
- Static IP address, default setting is 192.168.1.230
- Mask, default setting is 255.255.255.0
- Gateway, default setting is 192.168.1.1
- DNS, default setting is 192.168.1.1
- MAC address, default setting is 08:90:90:90:90:90
Click on “Save” to save these parameters and they are effective right now. After rebooting the
system, these settings will still be there. The configuration file that contains the settings is
“/etc/eth0-setting”.
Note: the “/etc/eth0-setting” file will not exist after reinstalling the system. Clicking on the “Save”
button will generate one. Because all products are tested extensively by us, this file exists in your
system. Executing the “ifconfig” command will not change this file. In fact, Qtopia has a network
setting utility by itself. But its interface is too complicated and may not work sometimes. We didn’t
make any change to this utility however created another one shown above.
The one Qtopia has is as follows:
Copy right reserved © MicroArm Systems, Inc. 1612 2
nd
Ave. SW PMB#108, Cullman, AL 35055 - 61 -
Website : www.microarmsystems.com Email: [e-mail] Phone: [phone]