User`s manual

High Performance Low Cost Embedded Systems
7.3.2 Installing Bootloader
The MINI2440 system has two bootloaders for WinCE: supervivi and nboot.bin, their differences
are listed in the table below:
supervivi Nboot
Image location \images\wince5.0 \images\wince5.0
Source code
location
No WindowsCE5.0\NBOOT
Project file No Nboot.mcp
Compiler Arm-linux-gcc ADS1.2
Note:
 Supervivi is maintained and developed by Friendly Arm, it is not open source
 NBOOT is open source
The following steps show how to download and write a supervivi to the MINI2440 board
(1) Start the DNW application, connect the board to a host PC via a USB cable. If the DNW’s
title bar shows “USB:OK” it indicates that the USB connection is a success. Select item [v] to
download a supervivi
(2) Go to “USB Port” -> “Transmit”, select a supervivi file (it is in the “\images\wince5.0”
directory in the installation CD) to start downloading
Copy right reserved © MicroArm Systems, Inc. 1612 2
nd
Ave. SW PMB#108, Cullman, AL 35055 - 216 -
Website : www.microarmsystems.com Email: [e-mail] Phone: [phone]