User`s manual

High Performance Low Cost Embedded Systems
(3) Start the DNW application. Connect the board to the PC via a USB cable. If the DNW’s title
bar shows “USB:OK”, it indicates the USB connection is a success. Go to “USB Port” -> “Backup
NandFlash to File”
On the pop up window shown below, pick up a destination folder and name a file that will store
the data. In this example, we saved the data in a “backup.bin” file
Copy right reserved © MicroArm Systems, Inc. 1612 2
nd
Ave. SW PMB#108, Cullman, AL 35055 - 202 -
Website : www.microarmsystems.com Email: [e-mail] Phone: [phone]