User`s manual

High Performance Low Cost Embedded Systems
Now let’s test the USB connection:
Connect the MINI2440 board to a host PC via a USB cable. Toggle the S2 switch to the
“Nor Flash” side.
Turn on the S1 switch, if this is the first time you connect, Windows XP will prompt that a new
USB device is found. Follow the steps below to install a USB driver:
(1) After the following window pops up, check the third option and click on the “Next” button
Copy right reserved © MicroArm Systems, Inc. 1612 2
nd
Ave. SW PMB#108, Cullman, AL 35055 - 19 -
Website : www.microarmsystems.com Email: [e-mail] Phone: [phone]