User`s manual

High Performance Low Cost Embedded Systems
(14) After the installation is done, click on the “OK” button
Note: if the user now clicks on “Start” -> “Programs” -> “Microsoft eMbedded Visual C++ 4.0”
-> “eMbedded Visual C++ 4.0”, it may not start successfully. The following window might show
up. The user needs install an SDK file to run it. The next section will introduce such an installation
procedure.
6.1.6 Installing EVC Patches and Exported SDK
To run an exported SDK correctly, the user should install EVC SP4 patch. It is located in the
“\Embedded VisualC++\SP\evc4sp4\DISK1” directory. This section details the steps to install
the patch files and then an exported SDK file.
Copy right reserved © MicroArm Systems, Inc. 1612 2
nd
Ave. SW PMB#108, Cullman, AL 35055 - 178 -
Website : www.microarmsystems.com Email: [e-mail] Phone: [phone]