User`s manual

High Performance Low Cost Embedded Systems
Select (*) Disabled, and click on the “OK” button to disable the firewall permanently. Now you can
start the NFS service:
(1) Start and Stop the NFS service
Run the command below:
#/etc/init.d/nfs start
This command will start the NFS service. The user can verify whether the service is running by
commanding:
# mount -t nfs localhost: /opt/FriendlyARM/mini2440/root_qtopia /mnt/
If no err messags come up, the user can then browse the contents of the “/mnt” directory and
verify if the contents are the same as the “/opt/FriendlyARM/mini2440/root_qtopia” directory.
Stop the service by commanding:
#/etc/init.d/nfs stop
(2) Starting the NFS service through the graphic interface
To auto run the service on system startup, the user can execute the command below:
# serviceconf
Open the system configuration window, on the left side of the window, check the NFS box,
click on the “Enable” button to start it.
Copy right reserved © MicroArm Systems, Inc. 1612 2
nd
Ave. SW PMB#108, Cullman, AL 35055 - 145 -
Website : www.microarmsystems.com Email: [e-mail] Phone: [phone]