User`s manual

High Performance Low Cost Embedded Systems
5.4 Uncompressing Source Code and Installing Application Utilities
This section will introduce how to uncompress all the source code that users may need and install
some application utilities including:
- Linux-2.6.29 kernel source code
- Qtopia source code (for x86 and arm)
- Busybox-1.13 source code
- Sample programs code (developed by FriendlyArm)
- Open source bootloader (vivi and u-boot)
- Boa and madplay
- Target file system directory
- File system image maker mkyaffsimage
- Linux logo maker: logo_maker
Note: all source code and utilities should be uncompressed and compiled with arm-linux-gcc-4.3.2
5.4.1 Uncompressing Source Code
Firstly, create a work directory: /opt/FriendlyARM/mini2440
After execute command “mkdir –p /opt/FriendlyARM/mini2440”, all the source code in the
following steps will be uncompressed in this work directory.
Copy right reserved © MicroArm Systems, Inc. 1612 2
nd
Ave. SW PMB#108, Cullman, AL 35055 - 140 -
Website : www.microarmsystems.com Email: [e-mail] Phone: [phone]