User`s manual

High Performance Low Cost Embedded Systems
After naming this connection another window will require you to select a serial port that will be
used to connect the MINI2440 board. Here we selected COM1:
Lastly, also the most important step is to set up the port properties. Note: you must select “No” in
the data flow control field otherwise you will only be able to see outputs. In addition the bits per
second should be set to 115200.
After setting up all properties, turn on the board’s power supply, if the connection gets set
properly, you will see a VIVI startup interface. If everything runs fine, please save this connection
for later use
Copy right reserved © MicroArm Systems, Inc. 1612 2
nd
Ave. SW PMB#108, Cullman, AL 35055 - 14 -
Website : www.microarmsystems.com Email: [e-mail] Phone: [phone]