Specifications

EP-BX7/BX7+

Award BIOS Setup

NOTE: If the hard disk Primary Master/Slave and Secondary Master/Slave are set to

Auto, then the hard disk size and model will be auto-detected.

NOTE: The “Halt On:” field is used to determine when to halt the system by the BIOS if

an error occurs.

NOTE: Floppy 3 Mode support is a mode used to support a special 3.5” drive used in

Japan. This is a 3.5” disk that stores only 1.2 MB, the default setting for this is

disabled.

4-2 BIOS Features Setup

Selecting the “BIOS FEATURES SETUP” option in the CMOS SETUP UTILITY menu allows

users to change system related parameters in the displayed menu. This menu shows all of the

manufacturer’s default values for the EP-BX7/BX7+.

Pressing the [F1] key will display a help message for the selected item.

Figure 3: BIOS Features Setup

Virus Warning: During and after the system boots up, any attempt to write to the boot

sector or partition table of the hard disk drive will halt the system and an error message will

appear.