Specifications

EP-BX7/BX7+
28
DIMM Module Installation & Removal
Figure 1 displays the notch marks and what they should look like on your DIMM
memory module.
DIMMs have 168-pins and two notches that will match with the onboard DIMM
socket. DIMM modules are installed by placing the chip firmly into the socket at a 90
degree angle and pressing straight down (figure 2) until it fits tightly into the DIMM
socket (figure 3).
CENTER KEY ZONE
(3.3 V DRAM)
LEFT KEY ZONE
(UNBUFFERED)
Open DIMM module clip before installing DIMM. When
DIMM is inserted the clip will raise into closed position.
To remove the DIMM module simply press down both
of the white clips on either side and the module will be
released from the socket.
Figure 1
Figure 2
Figure 3
HARDWARE INSTALLATION