Specifications

EP-BX7/BX7+

HARDWARE INSTALLATION

Directions & Recommended Tools

Thank you for using EPoX products! This chapter will discuss some general steps

needed in order to get your new mainboard installed and operational. The

EP-BX7/BX7+ is a high performance mainboard which allows the use of Intel

Celeron / Coppermine Socket 370 processors. The mainboard uses the ATX form

factor and requires a matching case. Below you will find our recommended installa-

tion procedure for fast and easy setup.

Step 1 - Configuration of Jumpers .................................................... 24

Step 2 - Installing into ATX case ....................................................... 25

Step 3 - Installing Connectors ........................................................... 26

Step 4 - Installing Memory ............................................................... 27

Step 5 - Installing Processor(s) ......................................................... 29

Step 6 -Device Connector Description ............................................. 31

Step7- Configuring KBPO & Modem Ring-in ................................. 33

Recommended Tools (Not Included)

Needle nose pliers: the all purpose needle nose

pliers is useful for many purposes such as, tightening

loose standoffs when no socket is available, holding

screws & jumpers, cutting plastic tie-offs, etc.

Phillips and flat-head screwdrivers: useful for the

actual mouting of the mainboard itself to the case as

well as hard drives, cards, CD-ROM drives, etc.