Instruction manual

3-18
MS-7033 M-ATX Mainboard
IDE Primary Master/Slave Ultra DMA
Ultra DMA 33/66/100/133 implementation is possible only if your IDE hard drive
supports it and the operating environment includes a DMA driver (Windows ME,
XP or a third-party IDE bus master driver). If your hard drive and your system
software both support Ultra DMA/33, Ultra DMA/66, Ultra DMA/100 and Ultra
DMA/133, select [Auto] to enable BIOS support. Setting options: [Auto], [Disabled].
SATA Devices Configuration
Press <Enter> and the following sub-menu appears:
On-Chip Serial ATA
This setting is used to specify the SATA controller. The settings are:
[Disabled]Disable the SATA controller.
[Auto] PATA and SATA will be arranged by BIOS, and you will be
able to see the IDE Device status listed in Standard COMS
Features.
[Combined] PATA and SATA will be combined. Max. of 2 IDE drives in each
channel are available.
[Enhanced] PATA and SATA will both be enabled. Max. of 6 IDE drives are
supported.
[SATA only] Only SATA is operating in legacy mode.
PATA IDE Mode
This item is available for you to select the parallel ATA channel. Setting options:
[Primary], [Secondary].
SATA Port
This allows you to set the boot sequence of serial ATA port.