Instruction manual

Getting Started
continued
RFT9739 Rack-Mount Transmitter Instruction Manual 5
Output Wiring Startup TroubleshootingBefore You Begin Getting Started Mounting
Power-Supply and
Sensor Wiring
2.3 Switch settings
Switches 1 through 10, located inside the transmitter on the control
board, control the following transmitter functions (see
Figure 1-1
,
page 2, for the location of the control board):
• Communications settings, including baud rate, stop bits and parity,
data bits, communication protocol, and physical layer
• mA outputs
• Zeroing method
• Write-protection of transmitter configuration
Switches are shown in
Figure 2-2
, and described in the following
sections. To access switches, remove the bottom cover of the transmitter
housing. Normally, switch settings do not require adjustment.
Figure 2-2.
Switches
Switches 1 through 10 at left
are shown in the OFF position.