Instruction manual

RFT9739 Rack-Mount Transmitter Instruction Manual 101
Appendix
E Transmitter Version
Identification
To identify a Version 3 RFT9739 rack-mount transmitter:
A Version 3 transmitter has a back-panel that is different from older
versions. For comparison, refer to
Figure E-1
.
• The Version 3 back panel has text between connectors CN1 and CN2,
which reads
BACKPLANE RFT9739RM PHASE 2/PHASE 3
.
• The Version 2 back panel does not have text between connectors CN1
and CN2 to identify the transmitter version.
• Earlier versions have a 3-position power-supply terminal block at
connector CN3.
Although an examination of the back panel can determine whether the
RFT9739 is a Version 3 transmitter, it does not identify the software
version.
To identify the software version:
1. When shipped from the factory, a sticker affixed to the side of the
transmitter housing identifies the transmitter software version.
2. If the identification sticker has been removed, use a HART device to
identify the software version. See one of the following
communications manuals for instructions:
•
Using the HART Communicator with Micro Motion Transmitters
•
Using ProLink Software with Micro Motion Transmitters
Figure E-1. RFT9739 back panels
Version 3 transmitters
Version 2 transmitters
Earlier versions