Instruction manual

RFT9739 Field-Mount Transmitter Instruction Manual 3
Output Wiring Startup TroubleshootingBefore You Begin Getting Started Mounting
Power-Supply and
Sensor Wiring
2 Getting Started
2.1 Hazardous area
installations
• Read the approvals tag before installing the RFT9739. The approvals
tag is attached to the transmitter housing. See
Figure 2-1
.
• For a complete list of UL, CSA, SAA, and European approvals, see
page 82.
• For intrinsically safe installations, use this manual with the appropriate
Micro Motion intrinsically safe installation instructions:
-
UL-D-IS Installation Instructions
-
CSA-D-IS Installation Instructions
-
SAA-D-IS Installation Instructions
• In Europe, refer to standard EN60079-14 if national standards do not
apply. To comply with CENELEC standards, see page 4.
Figure 2-1.
Hazardous area approvals
tag
WARNING
Failure to comply with requirements for intrinsic
safety in a hazardous area could result in an
explosion.
• Install the transmitter in an environment that is
compatible with the hazardous area specified on the
approvals tag. See
Figure 2-1
.
• For intrinsically safe installations, use this document with
Micro Motion UL, CSA, or SAA installation instructions.
• For hazardous area installations in Europe, refer to
standard EN 60079-14 if national standards do not apply.
Hazardous area
approvals tag